Balboa-water-group Plug N' Click Heater with NYROGEL 760G Uživatelský manuál stáhnout pdf

Installation Of A New Plug N’ Click Heater

– Turn off power to the system.

– Using a Phillips screwdriver remove the

2 screws on top of the enclosure and open the cover.

– Locate the 2 sensors holder on the circuit board.

– Remove the 2 heater sensors by depressing the

clip and gently pulling on the wire to remove

each sensor cable.

– Unplug the heater power connector by depressing

the holder clip to release the female connector.

– Remove the 2 heater nuts with a 3/8” (9.5mm)

open wrench.

– Remove heater from system.

PARTS AND TOOLS YOU NEED

– 3/8” (9.5mm) open end wrench

– 3/8” (9.5mm) nut driver

– Flat-head and Phillips screwdriver

– Replacement Balboa Heater

– Nyogel 760G (36308) and a stick

STEP 1 OPEN THE SYSTEM BOX

STEP 3 REMOVE THE 2 HEATER SENSORS

STEP 2 UNPLUG HEATER CONNECTOR

STEP 4 REMOVE NUTS ON HEATER

WARNING!

Please contact an electrician or your local electrical company when

connecting any spa electrical components. DO NOT OPEN THE SPA

SYSTEM AND ATTEMPT TO CONNECT THE CABLE CONNECTORS

YOURSELF. The high electrical voltage will harm or kill you.

Balboa Heater

Nyogel 760G (36308) and a stick

1 2

Installation Of A New Plug N’ Click Heater– Turn off power to the system.– Using a Phillips screwdriver remove the 2 screws on top of the enclosure

Žádné komentáře

Balboa-water-group Plug N' Click Heater with NYROGEL 760G Uživatelský manuál